Getting to eye level with wildlife subjects can be a bit of a challenge. Here’s one way to get down. I use a black flying disc to mount my camera on a gimbal. Beats trying to move a tripod along the ground by a mile. Read on to see my set up and reasoning below.
Why go low for wildlife photos?
When photographing wildlife, especially birds, the less you are noticed the better the capture of behavior. This brings me to a different way to mount your gimbal. Setting it up on a flying disc allows you to lay on the ground which makes you almost invisible to your avian friends. Meanwhile, many tripods will enable you to get your camera low to the ground. The multiple legs also make it difficult to change your position. The flying disc mount slides along the ground with no friction. Laying on the ground gives you the lowest profile possible. The sliding option enables you to move closer to your subject relatively undetected.
Flying disc
First bit needed is the disc. I use a 10.75 inch model that’s 175 grams. This is stiff and durable enough for the use. There are less expensive flying discs, but you need more stiffness than they supply.
Putting it together
Having a Platypod Handle gives you two options. You can use the smaller three inch section to get the gimbal high enough to not get caught on the edge of the disc. The easiest way to assemble is to mount the eXtreme on the Frisbee as outlined below. With a Platypod Handle, you have the option of using the three inch extension to allow clearance for the gimbal to rotate. This will be the lowest that the camera can be to the ground. For me that’s just a bit of a struggle to get that low. I find the Handle at full size to be just about perfect when resting on my elbows. Try both configurations to find the one that works best for you.
Here are parts you can use if you don’t have a Platypod Handle. Frisbee, Platypod eXtreme, Platypod spigot adaptor with 3/8 to 1/4 inch reducer, three 1/4X20 stainless steel rounded hex head bolts with rounded caps and a gimbal. Optional: Focusing rail if you have a heavy long lens that extends a fair distance.
Mount the Platypod eXtreme
You’ll need a drill with a 1/4 inch bit and a hex head wrench.
Mark two back holes and one front middle hole and drill 1/4 inch holes. Place the eXtreme over the drilled holes and feed the 1/4 inch stainless bolts through the Frisbee and thread until tight. Add the stainless caps to protect it from getting scratched. Add the spigot adaptor with reducer. Mount the gimbal. Mount your camera. With a super long lens that extends to throw off the balance you might want to add a macro focusing rail to make it easier to balance the camera and lens.
Not only does using the flying disc gimbal mount setup allow you to move closer to your target you achieve a more intimate view when photographing wildlife from eye level.
Sourcing materials
All of the Platypod mentioned parts can be found through B&H. Flying disc I got through Amazon. Stainless steel button head socket cap bolts with caps were at my local hardware store. If you don’t already have a gimbal head there are choices here.
Yours in Creative Photography,
Bob